Keyball61

Firmware

Please fork zmk-config-Keyball61.

Keymap Editor Dec'24 Compilation Error

Note on Keymap Compilation Issue

Due to recent updates in the Keymap Editor related to the ZMK mousekey, you may encounter a compilation error. To resolve this, please remove the line #include <dt-bindings/zmk/pointing.h> from config/keyballxx.keymap after you saved in the Keymap Editor.

1

After you Save the keymap in Keymap Editor

2

Go back to your own repo, make sure you choose the correct Branches (oled choose main, niceview or clone choose niceview). Then go to /config/keyballxx.keymap

3

Click the pen button to edit your code, delete the line #include <dt-bindings/zmk/pointing.h>.

4

After you deleted the line mentioned, Commit Changes.

This is not a one-time action; you need to repeat it every time you update your keymap in the Keymap Editor.

Battery Purchase Instructions

Please refer to this link.

3D Case

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

1. You may download, modify, and use these files for personal, non-commercial purposes only.

2. If you modify these files, you must share your modified files publicly under the same license.

3. Redistribution or sale of the files, including modified versions, for commercial purposes is strictly prohibited.

We usually use PLA with a 10-20% infill. Consider using Nylon for a better experience.

Low Profile Switch Plate

Replace the original 10mm MX screw with a 6mm M2 screw for the low-profile build.

1. 2.2mm 3D switch plate

2. 2.2mm 3D switch plate for thumb only

3. M2 screw 6mm length

Holder

For successful installation, use a 3mm bearing ball. If the fit is too loose, apply a suitable glue to secure it. If the ball fits directly without glue, your print is perfect. Note that the trackball sensor is very sensitive and may require some trial and error to function correctly

1. Wireless holder

MX Case

1. MX Case